#Router on a stick cisco manual
#Router on a stick cisco password
#Router on a stick cisco Pc

Save the running configuration to the startup configuration file.

R1(config)# banner motd $ Authorized Users Only! $

Create a banner that warns anyone accessing the device that unauthorized access is prohibited.

#Router on a stick cisco password

Assign cisco as the VTY password and enable login.

Assign cisco as the console password and enable login.Assign class as the privileged EXEC encrypted password.Disable DNS lookup to prevent the router from attempting to translate incorrectly entered commands as though they were host names.Console into the router and enable privileged EXEC mode.Step 2: Configure basic settings for the router. Step 1: Cable the network as shown in the topology.ДЄttach the devices as shown in the topology diagram, and cable as necessary.

#Router on a stick cisco Pc

In Part 1, you will set up the network topology and configure basic settings on the PC hosts and switches. Instructions Part 1: Build the Network and Configure Basic Device Settings

Ethernet cables as shown in the topology.

Console cables to co nfigure the Cisco IOS devices via the console ports.

2 PCs (Windows with a terminal emulation program, such as Tera Term).

2 Switches (Cisco 2960 with Cisco IOS Release 15.2(2) lanbasek9 image or comparable).

1 Router (Cisc o 4221 with Cisco IOS XE Release 16.9.4 universal image or comparable).

#Router on a stick cisco manual

If you are unsure, contact your Answers.ДЄnswers Note : Refer to the Answers Lab Manual for the procedures to initialize and reload devices. Note : Ensure that the routers and switches have been erased and have no startup configurations. Refer to the Router Interface Summary T able at the end of the lab for the correct interface identifiers. Depending on the model and Cisco IOS version, the commands available and the output produced might vary from what is shown in th e labs. Other routers, switches, and Cisco IOS versions can be used. The switches used in the labs are Cisco Catalyst 2960s with Cisco IOS Release 1 5.2(2) (lanbasek9 image). Note : The router s used with CCNA hands-on lab s are Cisco 4221 with Cisco IOS XE Release 1 6.9.4 (universalk9 image).

In this lab, you will create VLANs on both switches in the topology, assign VLANs to switch access ports, verify that VLANs are working as expected, create VLAN trunks between the two switches and between S1 and R1, and configure Inter-VLAN routing on R1 to allow hosts in different VLANs to communicate, regardless of which subnet the host resides. A particular kind of inter-VLAN routing, called вЂњRouter-On-A-StickвЂќ, uses a trunk from the router to the switch to enable all VLANs to pass to the router. Trunks allow the traffic from multiple VLANS to travel over a single link, while keeping the VLAN identification and segmentation intact. VLAN trunks are used to span VLANs across multiple devices. Routers in VLAN topologies provide additional security and traffic flow management. Communication between VLANs requires a device operating at Layer 3 of the OSI model. In general, VLANs make it easier to design a network to support the goals of an organization. VLANs address scalability, security, and network management. Modern switches use virtual local-area networks (VLANs) to provide segmentation services traditionally provided by routers in LAN configurations. Part 5: Verify Inter-VLAN Routing is working Background / Scenario Part 4: Configure Inter-VLAN Routing on the Router Part 3: Configure an 802.1Q Trunk between the Switches Part 2: Create VLANs and Assign Switch Ports Part 1: Build the Network and Configure Basic Device Settings